Back
The reliability of crown-root ratio, linear and angular measurements on panoramic radiographs.
Journal article

The reliability of crown-root ratio, linear and angular measurements on panoramic radiographs.

  • Stramotas S Discipline of Orthodontics, School of Dentistry, University of Sydney and Private Practice, Australia; Discipline of Orthodontics, School of Dentistry, University of Sydney, Australia; Discipline of Orthodontics, School of Dentistry, University of Sydney, Australia; Discipline of Orthodontics, University of Geneva, Switzerland; Discipline of Orthodontics, University of Detroit Mercy, Detroit; School of Mathematics, University of Technology, Sydney, Australia.
  • Geenty JP
  • Darendeliler MA
  • Byloff F
  • Berger J
  • Petocz P
Show more…
  • 2001-09-13
Published in:
  • Clinical orthodontics and research. - 2000
English The aim of this study was to evaluate the reliability of crown and root length, crown-root ratio and angular measurements of teeth relative to constructed reference lines and to other teeth in the same region on consecutive (T1 and T2) panoramic radiographs (OPGs). This retrospective study employed 20 cases; ten with five implants in each jaw (age range between 20 and 60 years) and ten with a full permanent dentition (age range between 12 and 16 years). The consecutive pairs of OPGs ranged from 6 months to 3 years apart. Four variables were measured and compared: 1) the crown or coronal segment length and the root or apical segment length; 2) the crown-root ratio; 3) the angulations of teeth and implants relative to specific reference lines in each jaw; 4) the angle between teeth and implants in the same sextant. The results revealed that comparisons of measurements taken of the same structures at T1 and T2, there were no statistically significant differences (p>0.05) between vertical linear measurements. The crown-root ratios and coronal-apical segment ratios too, showed no significant differences (p>0.05). Whereas, angulations of teeth or implants relative to respective reference lines showed significant differences (p=0.001) for some of the teeth. These differences, however, were less than 5 degrees; a clinically acceptable range. Angles measured between teeth or implants in the same sextant showed no significant differences (p>0.05). These results seem to support the hypothesis, therefore, that the linear vertical measurements, ratio calculations and angular measurements can be used to compare crown and root lengths, crown-root ratios and tooth angulations on OPGs taken of the same patient at different times with consistent accuracy.
Language
  • English
Open access status
closed
Identifiers
Persistent URL
https://sonar.rero.ch/global/documents/26308
Statistics
Document views: 9 File downloads: